Creality Ender 3 pro, has been well used but looked after. I levelled the bed and replaced original bed plate with a better one and this has given the prints used for the drawers (front and side) and the two shown in photo. I also have a laptop that can go with it, it is currently set up with Debian Trixie (Linux) and has Cura slicer installed and configured. It is old and slow but does all that is needed as it has tf card slot on side which matches the printer.

Fair Chance Policy: I’ll wait before choosing a recipient to give more people a chance to reply.

3d printer (Moorends DN8)